Initial commit

arduino/test/test.ino

@@ -0,0 +1,69 @@
+#include <fastspi_types.h>
+#include <fastspi.h>
+#include <controller.h>
+#include <fastled_config.h>
+#include <bitswap.h>
+#include <chipsets.h>
+#include <led_sysdefs.h>
+#include <lib8tion.h>
+#include <fastled_progmem.h>
+#include <fastspi_bitbang.h>
+#include <platforms.h>
+#include <noise.h>
+#include <dmx.h>
+#include <hsv2rgb.h>
+#include <fastspi_dma.h>
+#include <fastled_delay.h>
+#include <color.h>
+#include <fastpin.h>
+#include <FastLED.h>
+#include <colorutils.h>
+#include <fastspi_nop.h>
+#include <colorpalettes.h>
+#include <fastspi_ref.h>
+#include <pixeltypes.h>
+#include <power_mgt.h>
+
+#include <Wire.h>
+
+#define SLAVE_ADDRESS 0x12
+#define PIN_LED 13
+#define PIN_STRIP 6
+
+// Parameter 1 = number of pixels in strip
+// Parameter 2 = pin number (most are valid)
+// Parameter 3 = pixel type flags, add together as needed:
+//   NEO_KHZ800  800 KHz bitstream (most NeoPixel products w/WS2812 LEDs)
+//   NEO_KHZ400  400 KHz (classic 'v1' (not v2) FLORA pixels, WS2811 drivers)
+//   NEO_GRB     Pixels are wired for GRB bitstream (most NeoPixel products)
+//   NEO_RGB     Pixels are wired for RGB bitstream (v1 FLORA pixels, not v2)
+Adafruit_NeoPixel strip = Adafruit_NeoPixel(6, PIN, NEO_GRB + NEO_KHZ800);
+
+
+void setup() {
+    Wire.begin(SLAVE_ADDRESS);
+    Wire.onReceive(receiveData);
+    pinMode(PIN_LED, OUTPUT);
+    digitalWrite(PIN_LED, LOW);
+    
+strip.begin();// initialize strip
+strip.show();                // Update all LEDs (= turn OFF, since none of them have been set yet!)
+c = strip.Color(255, 0, 0);  // define the variable c as RED (R,G,B)
+strip.setPixelColor(2, c);  // set LED 10 to the color in variable c (red)
+strip.show();                // Update all LEDs (= make LED 10 red) 
+
+}
+
+void loop() {
+    delay(10000);
+}
+
+void receiveData(int byteCount) {
+    while(Wire.available()) {
+	if (1 == Wire.read()) {
+		digitalWrite(13, HIGH);
+	} else {
+		digitalWrite(13, LOW);
+	}
+    }
+}